Figure 3-1 Removing The Front/Rear Housing; Removing The Front And Rear Housing - Polaroid Miniportrait 204 Repair Manual

Repair Manual
A. Removing the Front and Rear Housing
1. Turn the system off.
2. Unlatch and remove the Camera Back (Figure 3-1) from the rear housing.
3. Remove the seven (7) phillips screws from the Rear Housing. There are
three (3) screws on each side (#6 x 5/8" phillips pan head) and one (1) in the
bottom center of the housing (#6 x 1/2" phillips black pan head). (Figure 3-1)
4. Gently separate the Front and Rear Housings enough to access the electrical
connectors.
5. Unplug the aiming light connector from J5 on the Logic Board. (Figure 3-2)
6. Unplug the strobe connector from J1 on the Power Board. (Figure 3-2)
7. Unplug the capacitor connectors from J3 on the Power Board. (Figure 3-2)
8. The Front and Rear Housings can now be fully separated so that internal
subassemblies can be repaired or replaced as necessary.
9. Reverse steps one (1) through seven (7) above to reassemble the housings.
#6 x 5/8"
phillips pan head
#6 x 5/8"
phillips pan head
Figure 3-1
#6 x 5/8" phillips
pan head
#6 x 1/2" phillips
pan head black phillips pan head
Removing the Front/Rear Housing
36
Model 204/404 MiniPortrait Camera
#6 x 5/8" phillips
pan head
#6 x 5/8" phillips
pan head
#6 x 5/8"
Camera
back