Table of Contents
Advertisement
Repair Manual
D.
Operating Instructions
(1)
Work area requirements
• Work area of at least 8 x 10 feet; avoid exposure to extreme temperatures
(avoid doors, windows, etc.).
• Table to support camera; 29 - 30 inches (76 cm) high.
• Electrical outlet (ground where applicable).
• Wastebasket.
• Non-reflective (felt or velvet) backdrop to place behind subject; backdrop
should be at least 30 inches (76 cm) square.
• Chair for subject to sit in; should be 17 - 18 inches (45 cm) high.
(2)
Preparing the camera for making ID photos
Note: Throughout this section, component names are followed by a letter in parenthesis. This
letter refers to the component location as depicted in Figures 1-1 and 1-2.
1. Place the camera on the table.
2. Pull out the silver release knob (I) on the
side of the camera base, and while holding it
out, grasp the camera head firmly and swing
it into the upright position. The knob will
click in when the camera is fully upright.
Note: The camera is pivoted to the lower position for
storage and transport
3. Tighten the black locking knob (J) under the
camera to prevent it from moving on the
camera base.
Note: If for any reason it is necessary to remove the
camera from the base, unscrew the black knob
.
completely
4. Place the backdrop on the wall and position
a chair in front of the backdrop.
.
13
Model 204/404 MiniPortrait Camera
40
60
0
40
60
0
60
40
I
60
40
J
Advertisement
Chapters
Table of Contents
Troubleshooting
