Polaroid Miniportrait 204 Repair Manual page 32

Repair Manual
Continued
PULL FILM message
stays on at all times;
even after film is pulled.
Film in camera, READY
is displayed, but nothing
happens when shutter
button is pressed.
Unable to access
Program Mode; menu
doesn't appear when
Program Mode button is
pressed.
PULL FILM message
appears when operator
attempts to change
Picture Select menu in
Program Mode
Pull film switch out of
adjustment. If yes, take
corrective action. If not,
see below.
Faulty pull film switch.
Operator attempted to
take picture after aiming
light went out. Or, aiming
light doesn't come on for
the reasons described in
(1.) and (2.)below.
(1.) Aiming light bulb
burnt out.
(2.) Aiming light switch
failed; not closing when
aiming button is pressed.
Defective shutter switch;
not closing when pushed
in.
PULL FILM displayed in
LCD panel. When in
PULL FILM mode,
Program Mode cannot be
accessed.
Operator attempted to
change Picture Select
menu prior to taking all
photos on the frame.
32
Model 204/404 MiniPortrait Camera
Adjust pull film switch.
Replace pull film switch.
Press aiming light button
again and take picture
before aiming light goes
out.
Replace bulb.
Replace aiming light
switch.
Replace shutter switch.
Pull the film frame.
When display reads
READY, Program Mode
can be accessed.
If it's necessary to
change the Picture
Select menu before all
photos on the frame are
used up, first pull the
film. When READY is
displayed, the menu can
be changed.