Figure 3-5 Replacing The Strobe Assembly; Replacing The Strobe Assembly - Polaroid Miniportrait 204 Repair Manual

Hide thumbs Also See for Miniportrait 204:

Table of Contents

Repair Manual

C. Replacing the Strobe Assembly

1. Turn the system off.

2. Unlatch and remove the Camera Back (Figure 3-1) from the rear housing.

3. Remove the seven (7) phillips screws from the Rear Housing. There are

three (3) screws on each side (#6 x 5/8" phillips pan head) and one (1) in the

bottom center of the housing (#6 x 1/2" phillips black pan head). (Figure 3-1)

4. Gently separate the Front and Rear Housings enough to access the electrical

connectors.

5. Unplug the following connectors: (a) aiming light connector from J5 on the

Logic Board; (b) strobe connector from J1 on the Power Board; and (c)

capacitor connector from J3 on the Power Board. (Figure 3-2)

6. Separate the Front and Rear housings for access to the Strobe Assembly.

(Figure 3-1)

7. Remove the two (2) #4 x 3/8" phillips screws securing the Strobe Assembly

(consisting of Strobe Board, Reflector and Flash Tube) to the housing.

(Figure 3-5)

8. Install a replacement Strobe Assembly.

9. Reassemble the camera by reversing steps one (1) through seven (7).

Figure 3-5

Model 204/404 MiniPortrait Camera

Strobe

assembly

phillips (2)

Strobe

connector

#4 x 3/8"

Table of Contents

Chapters

Table of Contents

Miniportrait 404