Figure 3-15 Lcd Display Board Removal; Replacing The Lcd Display Board - Polaroid Miniportrait 204 Repair Manual

Repair Manual
J. Replacing the LCD Display Board
1. Turn the system off.
2. Unlatch and remove the Camera Back (Figure 3-1) from the rear housing.
3. Remove the seven (7) phillips screws from the Rear Housing. There are
three (3) screws on each side (#6 x 5/8" phillips pan head) and one (1) in the
bottom center of the housing (#6 x 1/2" phillips black pan head). (Figure 3-1)
4. Gently separate the Front and Rear Housings enough to access the electrical
connectors.
5. Unplug the following connectors: (a) aiming light connector from J5 on the
Logic Board; (b) strobe connector from J1 on the Power Board; and (c)
capacitor connector from J3 on the Power Board. (Figure 3-2)
6. Separate the Front and Rear Housings.
7. Unplug the 20 pin parallel harness from the LCD Display Board.
(Figure 3-15)
8. Remove the #2 x 3/8" phillips pan head screw from each corner of the LCD
Display Board and lift out the board. (Figure 3-15)
9. Install the replacement LCD Display Board.
10. Reassemble the camera by reversing steps one (1) through seven (7).

Figure 3-15 LCD Display Board Removal

55
Model 204/404 MiniPortrait Camera
LCD display
board
#2 x 3/8"
phillips pan
head (4)
20-pin
parallel
harness