Repair Manual
Figure 4-19 Removing Front Lens Mounting Plate
5.
Remove the small phillips bindinghead screw, lever washer and wave
washer securing the Diaphragm (Aperture) Lever to the Diaphragm Base
Plate. Lift off the Diaphragm Lever. (refer to Figure 4-20 for steps 6.
Through 8.)
6.
Disengage the Diaphragm Springs from Diaphragm Leafs (a) and (b).
7.
Remove the four small phillips bindinghead screws and washers securing
the Diaphragm Base Plate to the Shutter Plate.
Caution: Take care not to lose the four flat washers located between
the Diaphragm Base Plate and Shutter Plate.
8.
Remove the Diaphragm Leafs from the center post on the Shutter Plate.
Shutter Plate
65
ID-200 Camera
Front Lens Mounting
Plate