Korg D3200 Owner's Manual page 20

35 LOC 1/IN, LOC 2/OUT, LOC 3/TO, LOC 4/END key
These keys are used to register a specific time location within a song, or to instantly jump to a reg-
istered time location.
The time locations registered here can be used as the punch-in/out locations, and to specify the
editing range for track editing operations such as copy or delete. (→p.38, 147)
You can also assign each key to a specific tab page within the MIXER page, so that pressing the key
will take you to that tab page (→p.147).
36 LOOP, TRIGGER, AUTO PUNCH indicators
These indicators will light to show which operation - loop record/playback, trigger recording, or
auto punch recording - is selected.
37 REC/PLAY MODE keys
Use this key to select the recording mode, or to turn loop playback on/off.
38 Transport keys
Use the REC, PLAY, STOP, REW, and FF keys to perform playback or recording operations on the
recorder. (→p.149)
39 DISPLAY UP/DOWN
By pressing this button on the back edge of the display, you can adjust the angle of the LCD screen
over five steps for best visibility.
Do not use excessive force to move the screen.
40 HDD/CD access and MIDI indicators
The HDD/CD indicator will light to indicate that the hard drive is being accessed for recording,
playback or editing, or when the CD-R/RW drive is operating. The MIDI indicator will light when
MIDI messages are received from the MIDI IN connector.
Never subject the D3200 to vibration or impact while this HDD/CD indicator is lit.
41 ON key, standby indicator
Pressing this key will turn the D3200 power on/off. When the standby indicator is lit, pressing the
ON key will turn the D3200 on.
When the D3200 is operating, hold down the ON key to access the Power Off dialog box.
42 Page mode keys
Pressing one of these keys will call up the corresponding page mode. When you press the CD key,
the corresponding page menu screen will appear.
43 UNDO key
The Undo function allows you to go back and listen to the audio as it was before an Edit was per-
formed. The Redo function brings back the edited result.
You can retrace your steps through as many as sixteen prior recording or editing operations.
(→p.141).
44 TUNER key
Press this key to access the Tuner screen, where you can check the tuning of the audio source that's
connected to the GUITAR IN jack.
45 Edit controller
Use these controllers to select a button, cell, or tab in the LCD screen, and to edit parameters and
values. The center-click ClickPoint, cursor (π†√®) keys, TAB PAGE /YES key, TAB PAGE /NO
key, and ENTER key let you edit quickly and efficiently.
46 +, – keys
These keys edit the value of the selected parameter as an alternative to using the value dial. These
keys are convenient when you want to adjust the value in single increments.
10