Category: Dynamics&Filter Dynamics/Filter-Type Effects - Korg D3200 Owner's Manual

Reso HiCut (Resonance High Cut)
Sets the resonance damping amount in the high range
Type
Waveform (LFO Waveform)
40: Mono Tremolo
*Speed (LFO Speed)
*Depth
Sets the depth of LFO modulation
Waveform (LFO Waveform)
Triangle, Sine, Square, Saw up, Saw down
Dry:Wet
Sets the balance between the effect and dry sounds
LFO Shape
Determines how much the LFO waveform is changed
41: Mn.Pitch Shifter
(Mono Pitch Shifter)
PitchShift
Sets the pitch shift amount in steps of a semitone
Fine
Sets the pitch shift amount in steps of one cent
Lo/Hi Cut (Low/High Cut)
Sets the damping amount in the low/high range
Dry:Wet
Sets the balance between the effect and dry sounds
Feedback
In Level (Input Level)
Category: Dynamics&Filter
Dynamics/Filter-type effects
42: Mono Compressor
Threshold
Sets the level at which compression begins to apply
Ratio
Sets the compression ration of the signal
Attack
Release
Response
Tube Sat (Tube Saturation)
Sets the depth of vacuum tube distortion
Out Gain (Output Gain)
53Hz...20.0kHz, THRU
Blue, U-VB
Selects the type of phaser
Triangle, Sine
Selects LFO Waveform
0.02...20.00Hz
Sets the LFO speed
0...100
Selects LFO Waveform
Dry, 1:99...99:1, Wet
–100...+100%
–24...+24/2tone
–100...+100cent
Lo:-50%..., Flat, ...Hi:-50%
Dry, 1:99...99:1, Wet
–100...+100%
Sets the feedback amount
0...100%
Sets the input level to the effect
–30.0...0.0dB
1.00:1...20.0:1
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
Slow, Medium, Fast
Selects the response speed
0...100
–24.0...+24.0dB
Adjusts the output level gain
43: Mono Expander
Threshold
Sets the level at which compression begins to apply
Ratio
Sets the compression ration of the signal
Attack
Release
Response
Out Gain (Output Gain)
44: Mono Limiter
Threshold
Sets the level at which compression begins to apply
Attack
Release
Out Gain (Output Gain)
Response
Tube Sat (Tube Saturation)
Sets the depth of vacuum tube distortion
45: Mono Gate
Threshold
Adjusts the level at which compression
Attack
Release
Range
Response
PreDelay (Pre Delay Time)
Out Gain (Output Gain)
46: Mono Filter
Fc Bottom (Control Fc Bottom)
Sets the lower limit of the frequency to be controlled
Fc Top (Control Fc Top)
Sets the upper limit of the frequency to be controlled
Resonance
Trim
FilterType
Control (Control Source)
Polarity
–48.0...0.0dB
1.00:1...20.0:1
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
Slow, Medium, Fast
Selects the response speed
–24.0...+24.0dB
Adjusts the output level gain
–48.0...0.0dB
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
–24.0...+24.0dB
Adjusts the output level gain
Slow, Medium, Fast
Selects the response speed
0...100
–48.0...0.0dB
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
–inf, –48...0.0dB
Compression level
Slow, Medium, Fast
Selects the response speed
0...200ms
Sets the delay time
–24.0...+24.0dB
Adjusts the output level gain
53Hz...20.0kHz
53Hz...20.0kHz
0...100%
Sets the resonance amount
0...100%
Adjusts the filter level
HPF, BPF, LPF
Selects the filter type
Envelope, LFO
Switches the control source
[+]Plus, [–]Minus
Inverts the control
161