Korg D3200 Owner's Manual page 167

22: Stereo Limiter
This effect applies the Limiter to the low range, mid range,
and high range of the input signal. You can control dynamics
for each range to adjust the sound pressure of the low range,
mid range, and high range in a different way from the EQ.
Threshold
Sets the level at which compression begins to apply
Attack
Release
Out Gain (Output Gain)
Env.Select (Envelope Select)
Switches the left/right channels between linked or independent
Response
Tube Sat (Tube Saturation)
Sets the depth of vacuum tube distortion
23: Stereo Gate
This effect lowers the level of input signals that are below a
specified level.
Threshold
Sets the level at which compression
Attack
Release
Range
Env.Select (Envelope Select)
Switches the left/right channels between linked or independent
Response
PreDelay (Pre Delay Time)
Out Gain (Output Gain)
: Pre Delay Time
This parameter sets the delay time of the Gate input. If the
sound has a very fast attack, increase the delay time so that the
signal will be input after the Gate is opened.
24: Stereo Filter
This is a filter with frequency control. It can be controlled by
a envelope or LFO.
Fc Bottom (Control Fc Bottom)
Sets the lower limit of the frequency to be controlled
Fc Top (Control Fc Top)
Sets the upper limit of the frequency to be controlled
Resonance
Trim
FilterType
Control (Control Source)
–48.0...0.0dB
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
–24.0...+24.0dB
Adjusts the output level gain
L/R Mix, L/R Indiv
operation
Slow, Medium, Fast
Selects the response speed
0...100
–48.0...0.0dB
0...1.00sec
Sets the attack time
0...10.0sec
Sets the release time
–inf, –48...0.0dB
Compression level
L/R Mix, L/R Indiv
operation
Slow, Medium, Fast
Selects the response speed
0...200ms
Sets the delay time
–24.0...+24.0dB
Adjusts the output level gain
53Hz...20.0kHz
53Hz...20.0kHz
0...100%
Sets the resonance amount
0...100%
Adjusts the filter level
HPF, BPF, LPF
Selects the filter type
Envelope, LFO
Switches the control source
Polarity
Dry:Wet
Sets the balance between the effect and dry sounds
Waveform (LFO Waveform)
*LFO Speed
LFO Step
L-R Phase (LFO L-R Phase)
Sets the LFO phase difference between the left and right
Env.Select (Envelope Select)
Links or un-links the left/right channels for envelope control
Env.Resp (Envelope Response)
Selects the response speed of envelope control
Env.Sens (Envelope Sensitivity)
Sets the sensitivity of envelope control
25: Stereo Wah
This is a wah effect that can be controlled by an envelope or
LFO.
Control (Control Source)
Env.Select (Envelope Select)
Links or un-links the left/right channels for envelope control
Env.Resp (Envelope Response)
Selects the response speed of envelope control
Env.Sens (Envelope Sensitivity)
Sets the sensitivity of envelope control
Waveform (LFO Waveform)
*LFO Speed
LFO Step
LFO Phase (LFO L-R Phase)
Sets the LFO phase difference between the left and right
Wah.Type (Wah Type)
Y-CRY, RM-A, RM-B, J-CRY, VOX, M-VOX
*Manual (Manual Control)
Sets the control position manually
DirectMix (Direct Mix Level)
Adjusts the mix level of the direct sound
Wah Level
:Manual
By selecting Manual as the Control Source, you can create the
effect of an actual wah pedal left in a fixed position.
Alternatively, if you assign an expression pedal to control Man-
ual, you can operate the expression pedal to control the sound
just like an actual wah pedal.
[+]Plus, [–]Minus
Inverts the control
Dry, 1:99...99:1, Wet
Triangle, Sine, Saw
Selects LFO Waveform
0.02...20.00Hz
Sets the LFO speed
0...256
Selects the LFO step
–180...+180deg
L/R Mix, L/R Indiv
Slow, Medium, Fast
0...100%
Envelope, LFO, Manual
Switches the control source
L/R Mix, L/R Indiv
Slow, Medium, Fast
0...100%
Triangle, Sine, Saw
Selects LFO Waveform
0.02...20.00Hz
Sets the LFO speed
0...256
Selects the LFO step
–180...+180deg
Selects the wah type
0...100
0...100%
0...100
Sets the wah level
157