Assembling The Stand; Cautions For Assembly; Assembling Procedure - Korg C-520 User Manual

Assembling the stand > Cautions for assembly

Assembling the stand

Cautions for assembly

• When placing the piano on the stand, be careful not to
pinch your hands.
• Be sure that the correct parts are assembled in the correct
orientation and position, and follow the steps in order.

Assembling procedure

1.
Open the packing carton and take out the contents. Check
that all of the following items are available.
Back panel
Sideboard A
(Left side)
Assembly Accessories
Screws (a) Screws (b)
(M4 x 14)...6pcs.
(M6 x 20)...4pcs.
Piano Fasteners
Cable holder
...2 pcs.
NB: You will need a cross-point (Phillips #2) screwdriver
for assembly.
2.
Screw the adjuster into the pedal box as far as it will go, and
attach the pedal cable.Use screws (a) to fasten the side pan-
64
Pedal Box Sideboard B
(Right side)
Caps...4pcs.
Adjuster...1pc.
...2 pcs.
• Do not apply weight to the front edge of the piano before
tightening the screws, otherwise the piano may fall down.
els to the pedal box. Make sure that there is no gap between
the side panels and the pedal box.
Screws (a)
Pull out the
pedal cable
This is used to adjust the height
after you've finished assembling
the stand; don't tighten it completely.
3.
With the finished surface (woodgrain) facing forward,
curve (bow) the back panel slightly and fit it into the
grooves of the side panel.
Slightly curve the back panel,
and fit it into the grooves
4.
Use screws (b) to fasten the side panels.
Start by fastening the bottom edge of the back panel (four
places). In two places, pass the screw through a cable
holder to attach it to the stand. Attach the power cable
holder at either the right side or the left side depending on
the position of the AC outlet you'll be using. Tighten these
screws.
Then fasten the top edge of the back panel (two places).
Don't tighten these screws completely yet, since you'll be
Align precisely, so that there is
no gap between the side panel
and pedal box.
Finished
surface
Grooves in side panels