Recording; Recording Video; Preparing To Record - Canon EOS C100 Mark II Instruction Manual

3

Recording Video

This section explains the recording basics. Before you begin recording, make a test recording first to check if the
camcorder operates correctly. Record an AVCHD clip at 28 Mbps for approximately 25 minutes and an MP4 clip
at 35 Mbps for approximately 20 minutes (A 54). Should the camcorder fail to operate correctly, refer to
Troubleshooting (A 185).
For details on recording audio, refer to Recording Audio (A 84).
Operating modes:

Preparing to Record

1 Attach a charged battery pack to the camcorder (
A
2 Attach a lens ( 31).
3 Attach the handle unit, grip unit, etc. as necessary to build the
desired configuration (
4 Adjust the viewfinder and OLED panel.
5 Insert an SD card into an SD card slot (
• Insert another SD card into the other SD card slot to use relay
recording (A 43) or double slot recording (A 43).

Recording

1 Set the Q switch to CAMERA (
• The camcorder turns on in
record pause mode.
• At first, both SD card access indicators will illuminate in
red. After a moment, the access indicator of the SD card
slot selected for recording will turn green and the other
access indicator will go out.
A 31).
A 41).
A
25).
mode and enters
A
24).
Recording
Rear tally lamp
SD card access indicators
47