Ftp File Transfer - Canon EOS C100 Mark II Instruction Manual

FTP File Transfer

FTP File Transfer
After connecting the camcorder to a network, you can transfer clips and photos from the camcorder to another
device connected to the network using the FTP protocol. The following explanations assume that the FTP server
158
is on, ready and correctly configured.
Operating modes:
Preparations
Before you can transfer clips to a connected device, you need to configure the FTP server settings and other
settings related to the handling of folders and files.
FTP Server Settings
To complete this procedure you will need detailed information about the FTP server that will be used as the
destination when transferring clips. If necessary, consult the network administrator in charge of the FTP server.
1 Open the [FTP Server Settings] submenu.
[w Other Functions] > [Network Settings] > [FTP Server Settings]
2 To enter the [FTP Server], select [Input] and then press the
joystick.
• Enter the FTP server's IP address or host name using the keyboard
screen (A 148).
• Though the FTP server's host name is not required when using
Camera Access Point connections, enter any characters to be able to
continue the procedure.
3 Enter the [User Name], [Password], and [Destination Folder] in the same way.
4 To enter the [Port No.], select [Input] and then press the joystick.
• Push the joystick up/down to select a value for the first digit and then press the joystick to move to the next
digit.
• After completing all the digits, select [Set] and then press the joystick.
5 Select [OK] and then press the joystick to confirm the port number.
6 Select whether to turn the passive mode [On] or [Off] and then press the joystick.
• [Off] is the standard setting for most cases. [On] (passive mode) is more appropriate for FTP transfers within
a network behind a firewall.
7 Select [OK] and then press the joystick to save the FTP server configuration.
8 When the confirmation screen appears, press the joystick.
[w Other Functions]
[Network Settings]
[FTP Server Settings]