Heat & Glo ATS-AU-D Installation And Operation Instructions Manual page 6

MODEL
ATS-AU-D
TABLE 1
WARNING: THE EXHAUST PIPE MUST
ONLY BE CONNECTED TO THE EX-
HAUST STARTING COLLAR OF THE
UNIT AND THE CENTER COLLAR OF
THE TERMINATION CAP.
THE INLET AIR PIPE MUST ONLY BE
CONNECTED TO THE INLET AIR COL-
LAR OF THE UNIT AND ATTACHED
TO THE INLET AIR COLLAR OF THE
TERMINATION CAP.
FIGURE 3
6
FLUE TERMINATION APPROVAL
LINK-DV30B
EXHAUST
AIR FLUE PIPE
Heat & Glo • ATS-AU-D • 327-900 Rev. F • 6/09
VERTICAL TERMINATION CAP
TERMINATION CAP
V = 3.0 m (10 FT.) MINIMUM
10 m (40 FT.) MAXIMUM
INLET AIR
FLUE PIPE