Clarion NXS09 Owner's Manual & Installation Manual page 57

USB Devices
Error 3
(USB memory)
Error 3 (iPod)
Error 5 (iPod)
Bus Error
Device Error
The connected USB device
is not supported.
An error occurred when
controlling the USB device.
The selected category has
no track data.
The iPod is frozen.
The connected iPod is not
recognized.
Over-current or data error
is detected.
The device is connected
via the USB Hub.
If the USB device is frozen, disconnect it, reset it,
and reconnect it again.
Connect a proper USB device.
Disconnect the USB device, and reconnect it
again.
Touch the [..A. (Track)] key. If the error is not
cleared, disconnect the iPod, and reconnect it
again.
Disconnect the iPod, reset it, and reconnect it
again.
Disconnect the iPod, and reconnect it again. If the
iPod is still not recognized, try replacing with a
different iPod.
If the iPod is frozen, disconnect it, reset it, and
reconnect it again.
Turn off the ignition switch, disconnect the device,
restart the engine and reconnect it again. If the
device is still not recognized, try replacing with a
different device.
Disconnect the device, and reconnect directly to
the USB connector of this unit without using the
USB Hub.
DRM WMA files protected by Perform the operation such as skipping a file.
DRM are played. (Repeat and random playback mode may be
t-N-o-t-S-u-p-p-o-rt----+-F-i-Ie-s-n-o-t-su-p-p-o-rt-e-d-b-y-t-h-is-l canceled.)
unit are played.
If an error display other than the ones described above appears, press the Reset button. If the problem
persists, turn off the power and consult your store of purchase.
• The frequencies of radio stations, setting data, etc. stored in memory are not cleared even when the
Reset button is pressed.
NX509
55