Clarion NXS09 Owner's Manual & Installation Manual page 48

.Adjusting the Bass
3-4. Touch the [Bass] key.
3-5. Touch the [-] or [+] key of the desired item
to adjust the effect level.
Gain: -7 to +7
• The factory default setting is "0".
Frequency: 50Hz, 100Hz,200Hz
• The factory default setting is "100Hz".
Q: 0.7, 1, 1.4, 2
• The factory default setting is "1".
.Adjusting the Mid
3-4. Touch the [Mid] key.
3-5. Touch the [-] or [+] key of the desired item
to adjust the effect level.
Gain: -7 to +7
• The factory default setting is "0".
Frequency: 500Hz, lkHz,2kHz
• The factory default setting is "1 kHz".
Q: 0.7,1,1.4,2
• The factory default setting is "1".
.Adjusting the Treble
3-4. Touch the [Treble] key.
3-5. Touch the [-] or [+] key of the desired item
to adjust the effect level.
Gain: -7 to +7
• The factory default setting is "0".
Frequency: 5kHz, 10kHz, 15kHz
• The factory default setting is "10kHz".
Q: 0.7,1,1.4,2
• The factory default setting is "1".
o
Adjusting the Balance/Fader
3-1. Touch the [BAUFAD] key to display the
BAUFAD tab screen.
3-2. Touch the
[~]
or
[~]
key of the Balance item
to adjust the balance level.
[~]:
Emphasizes the sound from the left
speakers.
[~]:
Emphasizes the sound from the right
speakers.
Adjustment range: left 12 to right 12
• The factory default setting is "0".
3-3. Touch the [.....] or [......] key of the Fader item
to adjust the fader level.
[
.....
]:
Emphasizes the sound from the front
speakers.
[
...... ]:
Emphasizes the sound from the rear
speakers.
Adjustment range: front 12 to rear 12
• The factory default setting is "0".
o
Setting the Sub Woofer
Control
You can adjust the volume output to the Sub
Woofer.
• The factory default setting is "0".
3-1. Touch the [Others] key to display the Others
tab screen.
3-2. Touch the [-] or [+] key of the Sub Woofer
Ctrl item to adjust the output level.
Setting range: -6 to +6
o
Setting the Sub Woofer Phase
You can reverse the phase of the Sub Woofer
output signal.
• The factory default setting is "Normal".
3-1. Touch the [Others] key to display the Others
tab screen.
3-2. Touch the [Reverse] or [Normal] key of the
Sub Woofer Phase item to select the phase
setting.
o
Adjusting the High Pass Filter
You can adjust the cut-off frequency of the High
Pass Filter for the front/rear speaker output.
• The factory default setting is "Through".
3-1. Touch the [Others] key to display the Others
tab screen.
3-2. Touch the
[~]
or
[~]
key of the High Pass
Filter item to adjust the setting.
Settings: Through, 60Hz, 90Hz, 120Hz
46
NX509