Clarion NXS09 Owner's Manual & Installation Manual page 39

Messages displayed during
reception
The following messages are displayed when the
satellite radio cannot be received normally.
.Sirius:
• When a channel is being tuned in or no signal
is received: "ACQUIRING SIGNAL"
• A channel without a broadcast has been
selected: "INVALID CHANNEL"
• A channel not covered by your contract: "CALL
888-539-SIRIUS TO SUBSCRIBE"
• When the tuner is turned on the first time or
after a reset: "UPDATING CHANNELS"
• When your contract is expired:
"SUBSCRIPTION UPDATED"
• When the Sirius antenna is not connected
correctly: "ANTENNA ERROR"
eXM:
• When a channel is being tuned in (no signal is
yet received): "LOADING"
• A channel without a broadcast has been
selected: "CHANNEL NOT AVAILABLE"
• A channel not covered by your contract:
"CHANNEL NOT AUTHORIZED"
• When a channel is out of air time: "CHANNEL
OFF AIR"
• When no signal is received: "NO SIGNAL"
• When the XM antenna is not connected
correctly: "CHECK ANTENNA"
Note:
• The messages may vary depending on the XM
tuners connected to this unit.
o
Selecting
a
band
1. Touch the [Band] key to select a band.
This changes the reception band as follows:
• Sirius: SR1 -+ SR2 -+ SR3 -+ SR1 .
• XM:XM1-+XM2-+XM3-+XM1 .
o
Confirming your Radio ID
.Sirius
1. Touch the [Options] key to display the
Options screen.
Your Sirius 10 (12-digit number) will be
displayed.
2. To return to the previous screen, touch the
[Back] key.
• XM
1. Touch the [Direct] key to display the Key Pad
screen.
2. Touch the [0] key, then touch the [ENT] key.
Receiving the Channel "0" will display your
Radio 10 (8-digit number).
o
Tuning in
a
station
Only channels that can be received are selected.
Channels without broadcasts and channels not
covered by the contract will be skipped.
1. Touch the [A (Channel)] or [T (Channel)]
key.
The system will tune to the previous or next
available channel.
• Holding the key continues to seek channels.
o
Selecting
a
station with the
channel number
1. Touch the [Direct] key to display the Key Pad
screen.
2. Enter the channel number of your desired
station by touching the [0] to [9] keys.
• If you enter a wrong number, you can
cancel it by touching the [BS] key.
• To return to the previous screen, touch the
[Back] key.
3. Touch the [ENT] key.
The radio channel you entered will be tuned.
o
Displaying the channel name
and other information
1. Touch the [Preset Info] key when the Preset
keys are displayed.
The channel name, category name, and other
information are displayed.
• When the information displayed is longer
than 16 characters, touching the text scrolls
the entire text.
2. To return to the Preset Key screen, touch the
[Preset Info] key again.
NX509
37