11 DMX master 3ch
This mode has the same functions as the "DMX master 5ch" mode, chapter 9. The difference
is the using of the DMX channels. In this mode only 3 DMX channels for controlling one unit
are used. In this mode other units than a LED PAR can be connected e.g. a power pack, LED
PARs of different companies which support control of a DMX master.
11.1 Mode setting
To enable the DMX master 3ch mode, set the 4pin dipswitch on the backside of the LED PAR
according to the this table:
SW4
SW3
X
1
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information below/above
11.2 Speed setting
SW4 setup the speed source. Choose the speed source according this table
SW4
SW3
0
X
1
X
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information above
11.3 DMX usage for 3ch control
The LED PAR in master mode sent DMX data according to the table below. The connected
slaves need to be set up to a 3 channel salve (see chapter 10).
1. DMX CH = RED
2. DMX CH = GREEN
3. DMX CH = BLUE
4. DMX CH = RED
5. DMX CH = GREEN
6. DMX CH = BLUE
7. DMX CH = RED
8. DMX CH = GREEN
9. DMX CH = BLUE
10. DMX CH = RED
11. DMX CH = GREEN
12. DMX CH = BLUE
SW2
SW1
mode
1
0
DMX master 3ch
SW2
SW1
mode
X
X
speed control by potentiometer, if selected mode support it
X
X
speed control by music, if selected mode support it
34