Dmx Operation - Pulse Cygnus User Instructions

connector
on the rear of the units. For longer cable runs we suggest a terminator at the last
fixture.
4. Turn on the all units' power, the units begins reset, then the unit begins working.
The
slave units will react the same as the master unit.
5. The units will react to the low frequencies of music via the internal microphone.
Adjust the audio sensitivity knob on the back of the master unit to make the unit more
or less sensitive in sound active. The panel has LED indicating for sound active.

DMX Operation

This mode allows you to use universal DMX-512 console to operate the laser.
1. Use standard XLR DMX cable chain your units together via the XLR connector
on the rear of the units. We recommend a terminator at the last fixture (ask your local dealer to
supply a PULSE DMXTERM-3P)
2. Assign a DMX address to each the unit using dipswitches
3. Power up the unit, the laser will then go through a reset cycle and begin operation in DMX
mode..
4. Use DMX console to control your units.
Operation:
We recommend this product is used within a 4 hour duty cycle. To do this the
•
unit should be operated for no more than 4 hours without then being left to
cool to room temperature and held at this temperature for 15 minutes. This
will prolong the life of the laser diode.
In accordance with HSG95 this product is fitted with a key switch & active
•
LED – the key switch is to allow operation of the device by persons who are
responsible and are competent to do so.
Do not operate in dusty or damp conditions. The cooling fan must be kept
•
clean and free of obstruction to prevent overheating.
9