Manual Mode; Mode Setting - Pulse STAGEPAR-108 User Manual

7 Manual mode

The LED PAR shows different fixed colours.
In this mode the LED PAR is used stand alone, the DMX output/input is not used.

7.1 Mode setting

To enable the manual mode, set the 4pin dipswitch on the backside of the LED PAR
according to the this table:
SW4 SW3 SW2
X 0
0 = dipswitch is set to off
1 = dipswitch is set to on
X = in this mode there is no speed control by potentiometer or music supported
SW1 mode
1 0 manual mode
16