Dmx Master 5Ch Mode; Mode Setting; Speed Setting - Pulse STAGEPAR-108 User Manual

9 DMX master 5ch mode

In this mode the LED PAR is a DMX controller in 5ch mode. The 5ch mode is build in for
controlling the new revision and old revision of the LED PAR. The connected slaves need to
be set to a 5ch DMX slave (see chapter 8.3).

9.1 Mode setting

To enable the DMX master 5ch mode, set the 4pin dipswitch on the backside of the LED PAR
according to the this table:
SW4 SW3
X 1
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information below

9.2 Speed setting

SW4 setup the speed source. Choose the speed source according this table
SW4 SW3
0 X
1 X
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information above
SW2 SW1 mode
0 0 DMX master 5ch
SW2 SW1 mode
X X speed control by potentiometer
X X speed control by music
23