5 Auto change mode
The LED PAR shows different colours depending on speed selection.
In this mode the LED PAR is used stand alone, the DMX output/input is not used.
5.1 Mode setting
To enable the auto change mode, set the 4 pin dipswitch on the backside of the LED PAR
according to the this table:
SW4
SW3
X
0
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information below
5.2 Speed setting
SW4 setup the speed source. Choose the speed source according this table
SW4
SW3
0
X
1
X
0 = dipswitch is set to off
1 = dipswitch is set to on
X = see information above
SW2
SW1
Mode
0
0
auto change
SW2
SW1
mode
X
X
speed control by potentiometer
X
X
speed control by music
12