When Incorrect Copies Are Produced - Konica Minolta BIZHUB 162 User Manual

When a message appears
8.5

When incorrect copies are produced

Symptom
The copy is too light.
The copy is too dark.
The copy is blurry.
The copy has dark specks or
spots.
The copy has lines.
bizhub 162/210
Possible cause
The copy density is set to
light.
The paper is damp.
The copy density is set to
dark.
The original is not held tightly
against the original glass.
The paper is damp.
The original is not held tightly
against the original glass.
The original glass surface is
dirty.
The document pad is dirty.
The original is highly transpar-
ent.
The original is 2-sided.
The imaging unit has reached
the end of its service life.
The document pad is dirty.
Remedy
Use the Auto/Photo key [)] to
select a darker copy density
(p. 3-54).
Change the paper. (p. 4-6)
Use the Auto/Photo key [*] to
select a lighter copy density
(p. 3-54).
Place the original in position
so that it is held tightly against
the original glass. (p. 4-12)
Change the paper. (p. 4-6)
Place the original in position
so that it is held tightly against
the original glass. (p. 4-12)
Wipe the original glass clean
with a soft, dry cloth. (p. 9-8)
Clean the document pad with
a soft cloth dampened with a
mild detergent. (p. 9-8)
Place a blank sheet of paper
over the original. (p. 4-13)
If a thin double-sided docu-
ment is being copied, the in-
formation on the back side
may be reproduced in the
copy. Use the Auto/Photo key
[*] to select a lighter density
for the background. (p. 3-54)
Contact your service repre-
sentative.
Clean the document pad with
a soft cloth dampened with a
mild detergent. (p. 9-8)
8
8-21