Basic Operations; Loading Paper; Loading Paper In Tray 1 - Konica Minolta BIZHUB 164 User Manual

3
3.2

Basic operations

3.2.1

Loading paper

This section describes how to load paper into each paper tray.
For the types of paper to be used, refer to page 12-3.

Loading paper in Tray 1

0 Make sure that the original and the loaded paper have the same orientation. Otherwise, some parts of
the image may be lost.
1
Pull out Tray 1.
2
Press down on the Paper-Lifting Plate until it locks into place.
% 1. Paper Take-Up Roller
NOTICE
Be careful not to touch the Paper Take-Up Roller.
3
Slide the Lateral Guides to fit the size of paper being loaded.
% To load the custom size, load the paper, then adjust the Lat-
eral Guides to the size of the paper being loaded.
4
Load the paper into the paper tray so that the side of the paper to
be printed on (the side facing up when the package was un-
wrapped) faces up.
% Do not load so many sheets of paper that the top of the stack
is higher than the , mark.
% If paper is curled, flatten it before loading it.
% Allows you to load up to 250 sheets of plain paper, or 20
sheets of card in the paper tray.
5
Close Tray 1.
6
Specify the paper size and paper type for Tray 1.
% Press the Menu/Select key ö [COPY JOB SETTING] ö [TRAY1 PAPER].
Settings
[SIZE]
[TYPE]
3-4
Select a paper size.
For details on how to configure a custom size, refer to page 3-6.
Select a paper type.
Basic operations 3.2
1
bizhub 164