Advertisement
Quick Links
C32CO Corner Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before
assembling or installing mantel kit.
These mantels are only approved for use with any
DESA Heating, LLC 32" electric and gas fireplace sys-
tem. Do not use mantel with any other product.
This mantel kit contains the following:
• Mantel pieces - unassembled and numbered as follows:
#1 Base
#2 Right Side Assembly
#4 Left Side Assembly
#4 Header
#5 Top
#6 Top Triangle
#7 Top Left Support
#8 Top Right Support
#9 Top Center Support
#10 Base Support
#11 Vertical Support
Right Top Trim Strip
Left Top Trim Strip
• Hardware Package
36 - 1
1
/
" Wood Screws
4
8 - 1" Finishing Nails
4 - 2" Wood Screws
* Extra hardware may be included
Tools required:
• Power Screwdriver with #2 Phillips Bit
• Hammer
• Nail Set
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement. If
hardware is missing or damaged, contact DESA Heating, LLC
at 1-866-672-6040 for referral information. You can also visit
DESA Heating, LLC's web site at www.desatech.com.
Note: Gather all mantel pieces together before assembling
mantel.
mantel. Damage to mantel will result if other screws
are used for this purpose.
114325-01
114295-01
122447-01
www.desatech.com
WARNING: Only use 1
/
" screws to assemble
1
4
Advertisement
Related Manuals for Desa C32CO
Summary of Contents for Desa C32CO
-
Page 1: Assembly And Installation Instructions
These mantels are only approved for use with any • Nail Set DESA Heating, LLC 32" electric and gas fireplace sys- If any wood pieces are missing or damaged, contact the tem. Do not use mantel with any other product. -
Page 2: Assembling Mantel
AssemblING mANTel Right Leg Assembly #2 " Important: more than one person is required to lift Screws assembled mantel. lift mantel by leg assemblies. lifting by header or mantel top could damage mantel. Left Leg Assembly #3 Use the following illustrations to assemble mantel. Use only screws provided. -
Page 3: Fireplace Installation
Fireplace Installation 1. Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual. Mantel Top Assembly 2. Mantel must be installed flush with two walls. Remove baseboard along walls where mantel is to be installed. Baseboard will prevent proper installation of mantel and base. -
Page 4: Mantel Installation
INsTAllATION 1. Carefully push mantel and base into position in corner This mantel can be used with DESA Heating, LLC electric and flush against both walls. Check operation of fireplace fireplaces. Electric fireplaces install from the front of mantel.