New Buck Corporation 85 Instruction Manual page 30

(a) Chimney pipe is 3' higher than roof at the point where it penetrates the roof.
(b) Chimney pipe height is at least 2 feet higher than any part of the roof within 10 feet of
chimney. (See Figure 12).
4. Next, install a New Buck Corporation chimney connector to the flue of the heater or use 3
"ELL" brackets and secure to topof heater and pipe.
5. Using single wall chimney connector, connectheater to the chimney by following
manufacturer's installation instructions exactly. (See Figure 13).
CEILING SUPPORT BOX
SINGLE WALL PIPE
CHIMNEY CONNECTOR
COLLAR COLLAR
3 SHEET METAL SCREWS
1. Recheck specified clearances.
2. Remove all foreign material from firebox area.
3. Open primary air draft.
NOTE: Plug power cord into a 115V AC outlet. Set switch to "Manual" and rheostat to
"High" position to ensure motor operates properly. Route cord to prevent damage to cord
insulation from heat and sharp objects. Keep cord out of the way of traffic to prevent damage
caused by tripping, etc.
Figure 13
FINAL CHECK
Page 28
3 SHEET METAL SCREWS OR RIVETS