Table of Contents
Advertisement
These models are designed for connection to:
(1) Simpson Duravent - Dura Black
(2) Metal Fab
(3) Ameritec - BSR
NOTE:
This
Room
with
requirements for Type HT chimneys in
Residential, Type and Building Heating Appliance, UL 103 or (2) a code approved masonry
chimney with a flue liner. The chimney size should not be less than nor more than 3 times
greater than cross-sectional area of flue collar.
SPECIAL METHODS ARE REQUIRED WHEN PASSING THROUGH A
WALL OR CEILING. SEE INSTRUCTIONS AND BUILDING CODES.
"DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING
ANOTHER APPLIANCE."
A. Ceiling Exits: (Using 6" Single Wall Pipe and UL 103 HT type chimney system
listed with manufacturer in this section of manual).
1. Suspend a plumb bob from ceiling above unit so that weight is hanging in center of
flue exit. (A small weight on a string will serve as a plumb bob). Mark ceiling where
string is suspended to locate the center of chimney.
2. After locating center of hole, install ceiling support box, chimney, flashing and rain cap per
chimney manufacturer's instructions.
3. Now connect stove and ceiling support box using #24 ga. minimum blue or black
steel connector pipe (DO NOT USE GALVANIZED PIPE). Connect each section so
crimped end faces downward and secure each section to each other using at least
three (3) sheet metal screws or rivets. Also use three (3) sheet metal screws to fasten pipe
to collar on heater. (See Figure 5. Page 16).
Chimney
Heater must be converted to (1) a
CAUTION
DETERMINING CHIMNEY LOCATION
Standard for chimneys, Factory-Built,
Page 15
chimney
complying
Hide quick links:
Advertisement
Table of Contents
