New Buck Corporation 85 Instruction Manual page 27

Drop cloth; 3/32" Metal drill bit; 5/16" Magnetic socket chuck adapter; 5/16" wrench (box or socket) or
adjustable wrench; Jigsaw with masonry, metal and wood blades.
WARNING: DO NOT INSTALL IN A SLEEPING ROOM.
Select an installation location that will give best airflow from front of
PREPARING STOVE FOR INSTALLATION
1. Inspect unit for any obvious physical damage.
2. Plug power cord into a 115V AC outlet to test fan and motor. Set switch to "Manual" and
rheostat to "High" position to ensure motor operates properly. Route the cord to prevent damage to
the cord insulation from heat and sharp objects. Keep cord out of the way of traffic to prevent
damage caused by tripping, etc.
3. Check primary air draft control to ensure that it slides freely.(See Figure 4).
4. Remove any items from within firebox. Spread a dropcloth on floor behind heater. Next, tilt heater
so that back is on drop cloth.
5. (Leg Kit): If legs are to be used, obtain four legs, attach legs to holes in bottom of unit with bolts
and washers supplied with leg kit. (See Figure 4).
6. (Pedestal Kit): If pedestal kit is being used and (out side air is required for residential free
standing installation (see page 25 Out Side Air Installation). Open freestanding kit and obtain
the stand. Place stand against bottom of heater (angle side to heater).Center stand front to rear
and also center stand left and right. Mark screw locations on bottom of stove through outer holes of
stand mounting angles. Set stand aside and drill four 7/32" holes in heater bottom. Before attaching
heater to stand, take a large flat screwdriver or pliers and remove 2" x 2" knockout on bottom of
unit. (See Figure 12A). Then mount stand to bottom of heater with screws provided. (See Figure 4A).
7. Obtain four (4) 3/16" self-tapping screws and secure stand to heater.
8. Reposition heater to upright position.
PRIMARY AIR
DRAFT CONTROL
TOOLS FOR INSTALLATION
heater to remainder of home.
HOLES FOR MOUNTING PEDESTAL
Figure 4A
Figure 4
Page 25
2" x 2"
KNOCKOUT
PEDESTAL