Radio Configuration; Entering Identity Information - Cisco Aironet 1200 Series Software Configuration Manual

Radio Configuration

Radio Configuration

Entering Identity Information

Cisco Aironet 1200 Series Access Point Software Configuration Guide
3-18
This section describes how to configure the access point's radio. You use the AP
Radio pages in the management system to set the radio configuration. The radio
pages include:
AP Radio Identification—Contains the basic locating and identity
•
information for the access point Radio port. See the
Information" section on page 3-18
Identification page.
AP Radio Hardware—Contains settings for the access point's SSID, data
•
rates, transmit power, antennas, radio channel, and operating thresholds. See
the "Entering Radio Hardware Information" section on page 3-21
instructions on using the AP Radio Hardware page.
AP Radio Advanced—Contains settings for the operational status of the
•
access point's radio port. You can also use this page to make temporary
changes in port status to help with troubleshooting network problems. See the
"Entering Advanced Configuration Information" section on page 3-29
instructions on using the AP Radio Advanced page.
• AP Radio Port—Lists key information on the access point's radio port.
You use the AP Radio Identification page to enter basic locating and identity
information for the access point radio.
Identification page.
Chapter 3
"Entering Identity
for instructions on using the AP Radio
Figure 3-10 shows the AP Radio
Configuration
for
for
OL-2159-01