Settings On The Ethernet Hardware Page - Cisco Aironet 1200 Series Software Configuration Manual

Chapter 3 Configuration

Settings on the Ethernet Hardware Page

Speed
OL-2159-01
The Ethernet Hardware page contains one setting:
The Speed drop-down menu lists five options for the type of connector,
connection speed, and duplex setting used by the port. The option you select must
match the actual connector type, speed, and duplex settings used to link the port
with the wired network.
The default setting, Auto, is best for most networks because the best connection
speed and duplex setting are automatically negotiated between the wired LAN and
the access point. If you use a setting other than Auto, make sure the hub, switch,
or router to which the access point is connected supports your selection.
Auto—This is the default and the recommended setting. The connection
•
speed and duplex setting are automatically negotiated between the access
point and the hub, switch, or router to which the access point is connected.
Some switches with inline power do not fully support Ethernet speed
Note
auto-negotiation. If your 350 series access point is powered by a
switch with inline power, the Auto speed setting is applied only after
you reboot the access point.
10-Base-T / Half Duplex—Ethernet network connector for 10-Mbps
•
transmission speed over twisted-pair wire and operating in half-duplex mode.
10-Base-T / Full Duplex—Ethernet network connector for 10-Mbps
•
transmission speed over twisted-pair wire and operating in full-duplex mode.
100-Base-T / Half Duplex—Ethernet network connector for 100-Mbps
•
transmission speed over twisted-pair wire and operating in half-duplex mode.
• 100-Base-T / Full Duplex—Ethernet network connector for 100-Mbps
transmission speed over twisted-pair wire and operating in full-duplex mode.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Ethernet Configuration
3-41