Chapter 4
Security Setup
Setting Up EAP Authentication
Enabling EAP on the Access Point
OL-2159-01
During EAP authentication, the access point relays authentication messages
between the RADIUS server on your network and the authenticating client device.
This section provides instructions for:
Enabling EAP on the Access Point
•
Enabling EAP in Cisco Secure ACS
•
•
Setting up a Repeater Access Point as a LEAP Client
You use the Authenticator Configuration page and the AP Radio Data Encryption
page to set up and enable EAP authentication.
Data Encryption page.
Figure 4-8
Authenticator Configuration Page
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Figure 4-8
shows the Authenticator Configuration page.
Setting Up EAP Authentication
Figure 4-6
shows the AP Radio
4-19