Cisco Aironet 1200 Series Software Configuration Manual page 198

Console and Telnet Setup
•
•
•
•
•
•
•
Cisco Aironet 1200 Series Access Point Software Configuration Guide
7-6
Data Bits—The default setting is 8.
Stop Bits—The default setting is 1.
Flow Control—Defines the way that information is sent between pieces of
equipment to prevent loss of data when too much information arrives at the
same time on one device. The default setting is None.
Terminal Type—The preferred setting is ANSI, which offers graphic features
such as reverse video buttons and underlined links. Not all terminal emulators
support ANSI, so the default setting is Teletype.
Columns—Defines the width of the terminal emulator display within the
range of 64 characters to 132 characters. Adjust the value to get the optimum
display for your terminal emulator.
Lines—Defines the height of the terminal emulator display within the range
of 16 characters to 50 characters. Adjust the value to get the optimum display
for your terminal emulator.
Enable Telnet—The default setting is Yes. Select No to prevent Telnet access
to the management system.
Chapter 7 Management System Setup
OL-2159-01