Vxdiag_Ipstatshow - Cisco Aironet 1200 Series Software Configuration Manual

Chapter 9 Diagnostics and Troubleshooting

:vxdiag_ipstatshow

OL-2159-01
Delay—delay interval in system clock-ticks (1/52 second) that must elapse
•
before the task runs
Follow the steps in the
open the CLI and enter the :vxdiag_i command.
Use the :vxdiag_ipstatshow command to display IP statistics for the access point.
The IP statistics might look like the following example:
total 5760
badsum
tooshort
toosmall
badhlen
badlen
infragments
fragdropped
fragtimeout
forward
cantforward
redirectsent
unknownprotocol
nobuffers
reassembled
outfragments
noroute
These are descriptions of each IP statistic:
• Total—the total number of packets received
Badsum—number of packets received with bad checksums
•
Tooshort—number of packets received that were shorter than the expected
•
length
Toosmall—number of packets received that did not have enough data
•
• Badhlen—number of packets received with IP header length less than the
packet data size
• Badlen—number of packets received with IP length less than the IP header
length
• Infragments—number of packets received that were fragmented
Cisco Aironet 1200 Series Access Point Software Configuration Guide
"Entering Diagnostic Commands" section on page 9-20
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Using Command-Line Diagnostics
to
9-27