Mazda 6 Installation Instructions Manual page 17

8．REINSTALLATION / INSPECTION
1. Reinstall parts in the reverse order of the installation procedure in【PARTS REMOVAL】.
2. After installing the passenger's side lower panel and glove compartment, measure the clearance, and verify that
Lower panel (Passenger's side)
Glove compartment
Standard value: 0.5-2.5mm
Standard value: 0.5-2.5mm
3. Refer to "Required servicing after disconnecting/connecting negative battery cable" in the vehicle workshop
manual or the owner's manual to restore the vehicle functions.
4. Perform reinstallation and inspection of the vehicle parts.
5. Register the controller (= RES ECU) with reference to the attached sheets "GENUINE REMOTE ENGINE
START【Parts No. C930 V7 620】Registration Procedure Of the Controller".
the measurement value is within the specification shown in the
figure.
CAUTION
 If the measurement value is not within the specification
after measuring the clearance between the passenger's
side lower panel and glove compartment, adjust the
passenger's side lower panel to the proper position.
17