Mazda 6 Installation Instructions Manual page 14

7．REMOTE ENGINE START INSTALLATION
110mm 100mm
ⓐ
RES ECU
Double-sided adhesive
tape
RES ECU
Harness 2 pin connector
100mm
Urethane tapeⓒ
50mm
50mm
ⓑ ⓒ
Urethane tapeⓐ
Antenna
Urethane tapeⓑ
TEMP Sensor
Fuse
1. Cut 1 piece of urethane tape to the dimensions shown in the
figure.
2. Wrap urethane tapeⓐ around the RES ECU.
CAUTION

Because the antenna is retractable, it may cause noise.
Wrap urethane tape from the end of the RES ECU to the
end of the antenna.
3. Degrease the RES ECU using primer, and affix double-sided
adhesive tape.
CAUTION

Use 3M Promoter-4298 for primer.

When degreasing using primer, only apply primer to the
degreased area to prevent other parts from becoming
discolored.

After degreasing using primer, let it dry for 1 min. or more.

Affix double-sided adhesive tape firmly.
4. Connect the TEMP sensor to the harness 2 pin connector.
5. Wrap the wiring harness and the TEMP sensor using the
urethane tape ⓑ.
CAUTION

Do not wrap urethane tape around the sensor part of the
TEMP sensor. The sensitivity of the sensor may be
affected if it is wrapped.
6. Wrap the fuse of the wiring harness using the urethane tape
ⓒ.
14