Table of Contents
Advertisement
Document exit and
upper turn roller areas
Removing non-jammed
documents
7-10
To clear the document exit and upper turn roller areas (Area D):
1. Turn off the power switch.
2. Lift up and open the upper access door.
3. Remove all jammed documents.
CAUTION: Be careful not to damage the antistatic brush when
removing the documents.
4. Close the upper access door.
After clearing the document path, follow the steps below to remove
any non-jammed documents.
1. Check the transport system for documents lodged in the document
path. The green handles and labels indicate operator-accessible
areas.
2. Make sure the horizontal and vertical transport plates, and the three
access doors are securely closed.
3. Turn the power on.
4. Press and hold the Jog key to clear any remaining documents in the
transport system. Repeat this step until all documents are in place in
the exit hopper.
5. Reset the image level, image address and application mode if
necessary.
6. Rescan documents in their original order.
A-61140 January 2000
Advertisement
Table of Contents
