Table of Contents
Advertisement
Adjusting the exit
hopper side guides
and end stop
2-8
The exit hopper side guides and end stop must be adjusted so
documents are stacked properly.
1. Adjust the exit hopper side guides to hold the widest document you
will be scanning. Leave ¼-inch (5 mm) clearance on each side of
the document.
2. Adjust the end stop to hold the longest document you will be
scanning.
An end stop extension is included to accommodate documents up to
17 inches in length.
To attach the end stop extension:
Fold the spring-loaded exit hopper end stop down and slide the
extension's tabs into the slits just above the exit hopper end
stop.
To remove the end stop extension:
Press the spring-loaded exit hopper end stop and pull the
extension out from the exit hopper.
End stop extension
Exit hopper
end stops
Tabs
A-61140 January 2000
Slits
Advertisement
Table of Contents
