Table of Contents
Advertisement
Operating keys and indicators
Keys/Indicators
Next
+
Enter
Back
CAL
End
Jog
Level 3 key
Level 2 key
Level 1 key
Run
Stop
Confirmation tone/alarm
1-8
Function
Allows you to enter the next document image address.
Allows you to enter a new value for the image address. When pressed, it
allows a field to remain unchanged.
Used to enter numeric data for a function code or an image address change.
Used to move the cursor back one space during numeric data input (the last
data input is erased).
Starts the calibration process.
Press End to stop the feeder and transport system at the end of a batch or
job and alert the host computer that the batch or job has ended. When
pressed, the documents in the transport system will be scanned and
stacked faced down in the exit hopper before the transport is disabled.
Momentarily turns on (jogs) the transport system to help clear document
jams.
Identifies the next document fed into the scanner as a Level 3 document.
Identifies the next document fed into the scanner as a Level 2 document.
Identifies the next document fed into the scanner as a Level 1 document.
Turns on the feeder and transport system.
Stops the feeder and transport system. When Stop is pressed, documents
in the transport system will be scanned and placed in the exit hopper before
the transport system stops.
The confirmation tone/alarm is located under the control panel and
sounds when one of the following conditions occur:
Run is pressed (one long tone).
Stop or End is pressed (many short tones followed by a long tone).
Feeder clutch engages/disengages (one short tone).
Incorrect key is pressed (three short tones).
Document skew is greater than what is setup in the skew parameter,
or when a document is shorter or longer than the specified length
parameters (one short tone).
A bar code is detected (if the accessory is enabled and the
confirmation tone is enabled).
A patch code is detected (if the accessory is enabled and the
confirmation tone is enabled).
The Footswitch is detected (if the accessory is enabled and the
confirmation tone is enabled — one short tone).
A-61140 January 2000
Advertisement
Table of Contents
