Kodak EasyShare 5300 User Manual page 25

Press to select Use Print Order if Found.
4
Press or to change the setting.
5
Press OK.
6
Scene Balance
Your EasyShare AiO is configurable to apply automatic scene balance improvements (brightness) for
photos printed on the AiO from camera cards and USB connected devices.. The default is to apply the
scene balance improvements.
Press Menu to display the main menu.
1
Press to select Photo Print Settings.
2
Press OK.
3
Press until Scene Balance is selected.
4
Press or to enable or disable Scene Balance.
5
Press OK.
6
Add Date to Prints
You can set your EasyShare AiO to print the date a picture was taken on the photo print. The default is to
not print the date.
Press Menu to display the main menu.
1
Press to select Photo Print Settings.
2
Press OK.
3
Press until Add Date to Prints is selected.
4
Press or to enable or disable date printing.
5
Press OK.
6
Button Sounds
You can configure your EasyShare AiO to emit an audio feedback beep when you press a button on the
Control Panel. The default setting is to beep.
Press Menu to display the main menu.
1
Press until Control Panel Settings is selected.
2
Press OK.
3
Press or to enable or disable button sounds.
4
Press OK.
5
Minutes to Standby
When the Kodak EasyShare All-in-One is idle for the standby power setting timeout period, it enters the
Standby state. The On/Off indicator remains lit, but power consumption is reduced. When in the Standby
User's Guide
Getting Started
21