Characteristics - Panasonic KX-TDA100D Installation Manual

1.3.2 Characteristics

1.3.2 Characteristics
Terminal Equipment Loop Limit
Minimum Leakage Resistance
Maximum Number of Extension
Instruments per Line
Ring Voltage
Trunk Loop Limit
Hookswitch Flash/Recall Timing
Range
BRI Cards Internal ISDN Mode
Door Opener Current Limit
External Relay Current Limit
External Sensor Current Limit
Paging Terminal Impedance
MOH (Music on Hold) Terminal
Impedance
*1 KX-TDA100DML: 75 Vrms
22 Installation Manual
• PT: KX-DT300/KX-T7600 series DPT: 90 W
• SLT: 600 W including set
• Doorphone: 20 W
• CS: 130 W; PT-interface CS: 65 W
15 000 W minimum
1.
for PT or SLT
2.
by Digital eXtra Device Port connection of 2 DPTs
65 Vrms at 20 Hz/25 Hz depending on the Ringing Load
*1
1600 W maximum
24 ms to 2032 ms
Supply Voltage: 40 V
Power Supply (BRI4): 4.5 W per 1 line, 9 W per 4 lines
Power Supply (BRI8): 4.5 W per 1 line, 9 W per 8 lines
Power Supply Method: Phantom Power Supply
24 V DC/30 V AC, 1 A maximum
24 V DC/30 V AC, 1 A maximum
Power to the external sensor is provided from the EIO4 card and must
be grounded through the EIO4 card. For the connection diagram, refer
to "2.6.4 EIO4 Card (KX-TDA0164)". The PBX detects input from the
sensor when the signal is under 100 W.
600 W
10 000 W