Error Messages - Panasonic KX-TG9391C Operating Instructions Manual

TG9391C(e).book Page 46 Wednesday, August 27, 2008 2:36 PM
Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.
Display message
Busy
Check tel line 1
Check tel line 2
Error!!
Failed
Incomplete
Memory full
Messages full
No link to base.
Reconnect AC adaptor.
Use rechargeable
battery.
You must first
subscribe to Caller
ID.
46
Cause/solution
L The called handset or base unit is in use.
L Other units are in use and the system is busy. Try again later.
L Privacy mode is on for the call you tried to join (page 20).
L The handset you are using is too far from the base unit. Move closer
and try again.
L The handset's registration may have been cancelled. Re-register the
handset (page 31).
L The supplied telephone line cord has not been connected yet or not
connected properly. Check the connections (page 12).
L If you use the unit as a single-line telephone only, erase the message
as follows:
To erase "Check tel line 1", press {MENU}. i
{#}{1}{8}{9}
To erase "Check tel line 2", press {MENU}. i
{#}{1}{9}{0}
When a power failure occurs, the message is displayed again. Erase
again as above.
L The handset's registration has failed. Move the base unit and
handset away from all electrical appliances and try again.
L Recording was too short. Try again.
L Phonebook copy failed (page 23). Confirm the other unit (the
receiver) is in standby mode and try again.
L Phonebook copy is incomplete. The receiver's phonebook memory
is full. Erase the unnecessary phonebook entries (page 22) from the
other unit (the receiver) and try again.
L The phonebook memory is full. Erase unnecessary entries (page
22).
L Message memory is full. Erase unnecessary messages (page 36,
37).
L Message memory is full. Erase unnecessary messages (page 36,
37).
L The handset has lost communication with the base unit. Move closer
to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit. Reconnect the
adaptor and try again.
L The handset's registration may have been cancelled. Re-register the
handset (page 31).
L A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on page
3, 14.
L You must subscribe to Call Display service. Once you receive caller
information after subscribing to Call Display service, this message
will not be displayed.