Display Assembly - HP ProBook 470 G2 Maintenance And Service Manual

Display assembly

Entire display hinge-ups are not spared.
For a list of individual display spare parts, see
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service doors (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. Keyboard (see
f. Top cover (see
Remove the display assembly:
1. Position the computer upside down.
2. Pull the antenna cables through from the bottom of the computer. Position the computer upside down,
and then remove the cables from the clips near the wireless modules (1), pulling the cables (2) through
the holes (3) in the computer.
Display components on page
Battery on page 35).
Service door on page
Hard drive on page 38)
Optical drive on page
WLAN/Bluetooth combo card on page
Keyboard on page 46)
Top cover on page 49)
36).
42)
44)
Component replacement procedures
19.
75