Gateway ALR 8200R User Manual page 118

108 Gateway ALR 8200R User's Guide
The disk drive LED illuminates continuously.
Probable Cause
The disk is corrupted.
The cable to the drive is
not connected properly.
An adapter card is not recognized by the system.
Probable Cause
The interrupt and/or I/O
address is set incorrectly.
The card has not been
configured through the
software (e.g., EISA
configuration utility).
The card was not installed
correctly.
Solution
Remove the disk from the drive. If the light remains
on, try restarting the system.
Open the system and check the cable between the
disk drive and its controller. Make certain the pins
are not bent or misaligned.
Solution
Check the address configuration of the adapter
card and ensure that it does not conflict with
another card in the system.
Configure the card with the appropriate software.
Reseat the card and make certain that its jumpers
are configured appropriately.