IBM System x3200 Type 4362 Problem Determination And Service Manual page 76

10. Push the drive into the bay.
11. Connect one end of the applicable signal cable into the rear of the drive and
12. Route the signal cable so that it does not block the airflow to the rear of the
13. If you have another drive to install or remove, do so now.
14. Connect the power cable to the rear of the drive. The connectors are keyed
58
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
left to remove it from the drive cage; then, snap the drive retainer clip into the
screw holes on the side of the drive (the blue side of the drive retainer clip
should be facing outward).
make sure that the other end of this cable is connected into the applicable
connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.