IBM System x3200 Type 4362 Problem Determination And Service Manual page 37

Select this choice to view the Startup Sequence Options menu. The startup
sequence specifies the order in which the server checks devices to find a boot
record. The server starts from the first boot record that it finds.
v Advanced Setup
Select this choice to change values for advanced hardware features, such as
CPU options and PCI configuration.
Important: The server might malfunction if these options are incorrectly
configured. Follow the instructions on the screen carefully.
This choice is on the full Configuration/Setup Utility menu only.
– CPU Option
Select this choice to view the Advanced Processor Options information.
– PCI Bus Control
Select this choice to view the system resources that are used by the installed
PCI or PCI-Express devices.
– IPMI
Select this choice to view the IPMI specification version, BMC
hardware/firmware version, system event log, LAN settings, and to enable or
disable the clear system event log and BIOS POST watchdog. Disable is the
default setting for clearing the system event log and BIOS POST watchdog.
- View System Event Log
Select this choice to view the System Event Log.
- LAN settings
Select this choice to view the Mini-BMC, IP, subnet, and gateway
addresses.
– NMI Option
Select this choice to enable or disable the NMI reboot. Enabled is the default
setting.
v Error Logs
Select this choice to view or clear error logs.
– Post Error Log
Select this choice to view the Post Error log entries.
– System Event/Error Log
Select this choice to view the system event and error messages that the
system generated during POST and runtime. Press Enter to erase the system
event/error log.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
v Exit Setup
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.
Chapter 2. Configuration information and instructions
19