IBM System x3200 Type 4362 Problem Determination And Service Manual page 67

ServeRAID-8s controller card; then, for each installed drive, attach one drop
from the 4-drop end of the cable to the drive backplate connector (see Figure 1
on page 48) on the drive cage backplate and connect the power connector to
a power drop on the system power cable. Route the cable as shown in the
following illustration.
ServeRAID-8s
4-drop cable
7. Replace the front system fan assembly.
a. Insert the fan assembly retaining tab over the right edge of the hard disk
drive backplate; then, rotate the fan assembly toward the backplate. Do not
fully close the fan assembly.
b. Route the 4-drop end of the combination signal and power cable through
one of the slots on the edge of the fan assembly; then, route the hard disk
drive power drop cable through the other slot on the edge of the fan
assembly. Ensure that the cables will not be pinched between the fan
assembly and the hard disk drive backplate when the fan assembly is
installed.
c. Rotate the fan assembly toward the backplate until the release tabs are
fully engaged.
d. Rotate the drive cage back into the server until it stops; then, press and
hold the retaining tab on top of the drive cage while rotating the drive cage
into the chassis until it locks into place.
8. Reconnect the fan assembly cable to the system board.
Note: Before you continue, check all internal power cables to make sure that
they are connected to the system board and other optional devices.
9. Install the side cover (see "Installing the side cover" on page 40).
10. Lock the side cover.
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 4. Removing and replacing server components
49