Programmable Softkeys - Cisco SPA 525G2 Administration Manual

Customizing Cisco SPA and Wireless IP Phones
Customizing Phone Softkeys
STEP 1
STEP 2
STEP 3
STEP 4
NOTE
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
Keyword Key Label
unpark Unpark
xfer Transfer/
xfer
xferLx Xfer Line/
xferLx

Programmable Softkeys

The Cisco SPA 300 Series and Cisco SPA 500 Series IP Phones provide six
programmable softkeys (fields PSK 1 through PSK 6). These keys can be defined
by either a speed dial script or an XML service script.
To configure programmable softkeys:
Log in to the configuration utility.
Click Admin Login and advanced.
Click the Phone tab.
(Cisco SPA 525G/525G2 only) Under Programmable Softkey Enable, choose yes.
To configure a speed dial script, enter the following in the PSK field:
extensionname
fnc=sd;ext=
fnc
where is the function of the key (speed dial), ext (
extension being dialed,
outbound call is sent, and
name
The field displays on the softkey on the phone display screen. Cisco
recommends a maximum of 8 characters for a Cisco SPA 30X or Cisco SPA 50X
phone and 10 characters for a Cisco SPA 525G/525G2 phone. If more characters
are used, the label can be truncated on the phone display.
To configure an XML script, enter the following in the PSK field:
Definition
Resumes a parked call.
Performs a call transfer. Requires
that Attn Xfer Serv is enabled and
there is at least one connected call
and one idle call.
Transfers an active line on the
phone to a called number.
Requires that Attn Xfer Serv is
enabled and there are two or more
calls that are active or on hold.
outboundextnum
@$PROXY;vid=
vid
is the extension on the calling phone from which the
name
is the name of the speed dial being configured.
Available Phone
States
Idle, Off-Hook (no
input)
Connected, Start-
Xfer
Connected
name
;nme=
extensionname
) is the
3
56