Mvme2603/2604 Vmemodule Installation - Motorola MVME2603-1121A Installation And Use Manual

MVME2603/2604 VMEmodule Installation

1
MVME2603/2604 VMEmodule Installation
!
Caution
1-42
6. At the other three corners of the base board, install long (0.737
inch) standoffs.
7. Place the PMC carrier board on top of the base board. The
connector on the underside of the carrier board should
connect smoothly with the corresponding connector J5
(located between P1 and P2) on the MVME2603/2604.
8. Insert the four short Phillips screws through the holes at the
corners of the carrier board, into the standoffs on the
MVME2603/2604. Tighten the screws.
9. Reinstall the MVME2603/2604 assembly in its proper card
slot. Be sure the module is well seated in the backplane
connectors. Do not damage or bend connector pins.
10. Replace the chassis or system cover(s), reconnect the system
to the AC or DC power source, and turn the equipment
power on.
With mezzanine board(s) installed and headers properly
configured, proceed as follows to install the MVME2603/2604 in
the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
2. Perform an operating system shutdown. Turn the AC or DC
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
Inserting or removing modules with power applied
may result in damage to module components.