Overview Of Startup Procedure; Table 1-2. Startup Overview - Motorola MVME2603-1121A Installation And Use Manual

Overview of Startup Procedure

1
Overview of Startup Procedure
What you need to do...
Unpack the hardware.
ConÞgure the hardware by
setting jumpers on the boards
and transition modules.
Ensure memory mezzanines
are properly installed on the
base board.
Install the MVME2603/2604
VMEmodule in the chassis.
Install the transition module in
the chassis.
Connect a console terminal.
Connect any other equipment
you will be using.
Power up the system.
1-4
In models of the MVME2603/2604 that are configured for
MVME712M I/O mode, the pin assignments of VMEbus connector
P2 are fully compatible with other transition modules of the
MVME712 series. In MVME761-compatible models, certain signals
are multiplexed through P2 for additional I/O capacity. Refer to
Signal Multiplexing in Chapter 3 for details.
The following table lists the things you will need to do before you
can use this board and tells where to find the information you need
to perform each step. Be sure to read this entire chapter, including
all Caution and Warning notes, before you begin.

Table 1-2. Startup Overview

Unpacking Instructions
MVME2603/2604 Base Board Preparation and
MVME712M Transition Module Preparation or
MVME761 Transition Module Preparation
RAM200 Memory Mezzanine Installation
MVME2603/2604 VMEmodule Installation
MVME712M Transition Module Installation or
MVME761 Transition Module Installation
System Considerations, MVME2603/2604
VMEmodule
Connector Pin Assignments
For more information on optional devices and
equipment, refer to the documentation provided
with the equipment.
Applying Power
Troubleshooting CPU Boards ; Solving Start-Up
Problems
Refer to...
P2
On page...
1-5
1-6 and
1-15 or 1-25
1-33
1-35
1-38
or 1-41
1-46
4-1
2-1
D-1