Table of Contents
Advertisement
MVME761 Transition Module Installation
1
MVME761 Transition Module Installation
!
Caution
!
Caution
!
Warning
1-48
This section applies to MVME761-compatible models of the
MVME2603/2604 VMEmodule. With the MVME2603/2604
installed, refer to
Figure 1-22
MVME761 transition module:
1. Attach an ESD strap to your wrist. Attach the other end of the
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
2. Perform an operating system shutdown. Turn the AC or DC
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
MVME2600-1XXX (MVME761-compatible models) will
be damaged if they are mistakenly connected to the
MVME712 family of boards instead of the correct
MVME761 transition modules.
Inserting or removing modules with power applied
may result in damage to module components.
Dangerous voltages, capable of causing death, are
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
3. Remove the filler panel(s) from the appropriate card slot(s) at
the front or rear of the chassis. (You may need to shift other
modules in the chassis to allow space for the cabling to the
MVME761.)
4. Attach the P2 adapter board to the P2 backplane connector at
the slot occupied by the MVME2603/2604 VMEmodule.
and proceed as follows to install an
Hide quick links:
Advertisement
Table of Contents
