Figure 1-19. Pmc Module Placement On - Motorola MVME2603-1121A Installation And Use Manual

4. Remove the PCI filler from the front panel.
Figure 1-19. PMC Module Placement on MVME2603/2604
5. Slide the edge connector of the PMC module into the front
panel opening from behind and place the PMC module on
top of the base board. The four connectors on the underside
of the PMC module should then connect smoothly with the
corresponding connectors (J11/12/13/14) on the
MVME2603/2604.
6. Insert the two short Phillips screws through the holes at the
forward corners of the PMC module, into the standoffs on the
MVME2603/2604. Tighten the screws.
7. Reinstall the MVME2603/2604 assembly in its proper card
slot. Be sure the module is well seated in the backplane
connectors. Do not damage or bend connector pins.
8. Replace the chassis or system cover(s), reconnect the system
to the AC or DC power source, and turn the equipment
power on.
Hardware Preparation and Installation
1
11661.00 9611 (3-3)
1-39